Thermistor THRM-QC-MEDLRG for EcoSmart ECO 18, 21, 24, 27 and 36, plus Rheem RTEX & Eemax HomeAdvantage/ProAdvantage
MAKE SURE YOUR THERMISTOR TIPS (plug connectors) EXACTLY MATCH as shown in the two product photos above! NO RETURNS ON THIS ITEM. You may call EcoSmart tech support for assistance at 877-474-6473.
Also 100% compatible with the following heater models:
≈ iHeat/Drakken AHS27D, AHS18D, AH27, AH18
≈ Eemax HomeAdvantage HA018240, HA027240, HA036240
≈ Eemax ProAdvantage PR018240, PR027240, PR036240
≈ Eemax EEM24018, EEM24027, EEM24036 (blue color units)
≈ Rheem RTEX-18, RTEX-27, RTEX-36
≈ Rheem RETEX-18, RETEX-27, RETEX-36
≈ Richmond RMTEX-18, RMTEX-27, RMTEX-36
ECO 18, ECO 21, ECO 24, ECO 27 and ECO 36 Thermistors Troubleshooting Steps
Turn off breaker.
Locate temperature sensors on inlet and outlet pipes. It is the nut with wires coming out of it.
Follow cable to electronic board.
Remove electronic board cover.
Disconnect from board.
Turn on breakers.
Turn on hot water tap.
Wait 3 to 5 minutes.
If water still does not heat up, further technical troubleshooting is needed. Volt meter is required.
If the water heats up, then the thermistors are bad. Just leave them disconnected (creating a bypass) until you can replace the thermistors.
EcoSmart tankless water heater technical overview
The ECO 18 is the medium sized model and carries (2) heating elements and exchangers using (2) 9 kW @ 240 Volts.
The ECO 21, ECO 24, ECO 27 and ECO 36 have the largest-sized form factor and they each use heating elements and exchangers. The ECO 21 uses three 7 kW elements running at 240 Volts. The ECO 24 uses three 8 kW elements operating at 240 Volts. The ECO 27 uses three 9 kW elements running at 240 Volts. The ECO 36 uses four 9 kW elements running at 240 Volts.
|1. Electrical Conduit Connection
|2. Flow Sensor
|3. Ground Connector
|4. Terminal Block
|5. Triac Cooling Plate
|7. Temperature Control Setting Knob
|8. Inlet Temperature Sensor
|9. Electronic Board and Protector
|10. Fuse and Fuse Holder
|11. Copper Heating Elements
|13. Mounting Bracket
|14. Back Casing
|15. Copper Heat Exchanger
|16. Outlet Temperature Sensor
|17. Hot Water Outlet Connection
|18. Cold Water Inlet Connection